scd5900 rev g features ? single power supply operation (3.3v to 5.0v) or dual power supply operation (1.65 to 2.5v) ? radiation performance - total dose: >1mrad(si); dose rate = 50 - 300 rads(si)/s - eldrs immune - sel immune >100 mev-cm 2 /mg - neutron displacement damage >10 14 neutrons/cm 2 ? rail-to-rail input and output range ? short circuit tolerant ? full military temperature range ? designed for aerospace and high reliability space applications ? packaging ? hermetic ceramic soic - 16-pin, .411"l x .293"w x .105"ht - weight - 0.8 grams max ? aeroflex plainview?s radiation har dness assurance plan is dla certif ied to mil-prf-38534, appendix g. radhard-by-design general description aeroflex?s rhd5900 is a radiation hardened, single supply, quad operational am plifier in a 16-pin soic package. the rhd5900 design uses specific circuit to pology and layout methods to mitigate total ionizing dose effects and single event latchup. these character istics make the rhd5900 especially suited for the harsh environment encountered in deep space miss ions. it is guaranteed operational from -55c to +125c. available screened in accordance with mi l-prf-38534 class k, the rhd5900 is ideal for demanding military and space applications. organization and application the rhd5900 amplifiers are capable of rail-to-rail input and outputs. performance characteristics listed are for general purpose operational 5v cmos amplifier applications. the amplifiers will drive substantial resistive or capacitive loads and are unity gain stable under normal conditions. resistive loads in the low kohm range can be handled without gain derating and capacitive loads of several nf can be tolerated. cmos device drive has a negative temperature coeffici ent and the devices are therefore inherently tolerant to momentary shorts, although on ch ip thermal shutdown is not provid ed. all inputs and outputs are diode protected. the devices will not latch with seu events to above 100 mev-cm 2 /mg. total dose degradation is minimal to above 1mrad(si). displacement damage environments to neutron fluence equivalents in the mid 10 14 neutrons per cm 2 range are readily tolerated. there is no sensitivity to low- dose rate (eldrs) effects. seu effects are application dependent. standard products april 8, 2013 www.aeroflex.com/rhdseries rhd5900 quad operational amplifier
2 scd5900 rev g 4/8/13 aeroflex plainview 16-pin soic out_a -in_a +in_a vcc +in_b -in_b out_b n/c out_d -in_d +in_d vee +in_c -in_c out_c n/c rhd5900 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 notes: 1. package and lid are electric ally isolated fr om signal pads. 2. it is recommended that n/c or no connect pins (pins 8 and 9) and lid be grounded. this eliminates or minimizes any esd or s tatic buildup. out_b out_a out_c out_d 3 2 5 6 12 11 14 15 16 10 7 1 +in_a -in_a +in_b -in_b +in_c -in_c +in_d -in_d a b c d 4 13 vcc vee figure 2: package pin-out figure 1: block diagram
3 scd5900 rev g 4/8/13 aeroflex plainview absolute maximum ratings parameter range units case operating temperature range -55 to +125 c storage temperature range -65 to +150 c junction temperature +150 c supply voltage v cc - v ee +6.0 v input voltage v cc +0.4 v ee -0.4 v lead temperature (soldering, 10 seconds) 300 c thermal resistance, junction to case, ?? jc 7 c/w esd rating (mil-std-883, method 3015, class 2) 2,000 - 3,999 v power @25c 200 mw notice: stresses above those li sted under ?absolute maximum ratings? may cause permanent damage to the device. these are stress rating only; functional operation beyond the ?operati on conditions? is not recommended and exte nded exposure beyond the ?operation condition s? may affect device reliability. recommended operating conditions symbol parameter typical units +v cc power supply voltage 3.3 to 5.0 v v cm input common mode range v cc to v ee v electrical perform ance characteristics (t c = -55c to +125c, +v cc = +5.0v -- u nless otherwise specified ) parameter symbol conditions min typ max units quiescent supply current 1 /i ccq no load 4.7 5.5 ma input offset voltage 1 /v os -3 0.80 3 mv input offset current 1 /i os -100 10 100 pa input bias current i b t c = +25c, -55c 1 / -100 10 100 pa t c = +125c -1000 100 1000 common mode rejection ratio cmrr 70 90 db power supply rejection ratio psrr 70 90 db output voltage high v oh r out =3.6k to gnd 4.9 v output voltage low v ol r out =3.6k to v cc 0.1 v short circuit output current 2 / i o ( sink )v out to v cc -30 -75 ma i o ( source )v out to v ee 45 55 ma slew rate 1 /srr l = 8k, gain = 1 2.0 3.3 v/us open loop gain 1 /a ol no load 90 100 db unity gain bandwidth 1 /ugbwr l = 10k 4 6.5 mhz channel separation 2 /r l = 2k, f = 1.0khz 84 db input-referred voltage noise 2 / e n f = 5 khz 15 nv/ phase margin 2 / ? m t c 25 c, no load 30 deg notes: 1 / specification derated to reflect to tal dose exposure to 1 mrad(si) @ +25c. 2 / not tested. shall be guaranteed by design, characte rization, or correlation to other test parameters. hz
4 scd5900 rev g 4/8/13 aeroflex plainview r1 r2 v out v in inverting amplifier vout vin r2 r1 ------ - ? ? ? ? ? = -2.5v +2.5v v in v out r2 r1 non inverting amplifier vout vin 1 r2 r1 ------ - ? ? + ? ? = -2.5v +2.5v application note 1: dual power supply amplifier inverting amplifier r1 r3 v out v in +5v r4 r2 +5v v bias vout vin r2 r1 ------ - ? ? ? ? ? = non inverting amplifier r1 r3 v out v in r4 r2 +5v +5v v bias vout vin 1 r2 r1 ------ - ? ? + ? ? = note: for v out dc @ mid range of common mode voltage range, v bias = 2.5/(1+r2/r1), v bias = +5*r4/(r3+r4) application note 2: single power supply amplifier rhd5900 quad operational amplifier application notes
5 scd5900 rev g 4/8/13 aeroflex plainview differential input amplifier r1 r3 v out v1 v2 r4 r2 vout v2 r4 r3 r4 + -------------------- - ?? ?? 1 r2 r1 ------ - + ?? ?? ?? ?? v1 r2 r1 ------ - ?? ?? ? = vee vcc application note 3: diffe rential input amplifier figure 3: package outline note: package and lid are electrically isolated from signal pads.
scd5900 rev g 4/8/13 6 plainview, new york toll free: 800-the-1553 fax: 516-694-6715 se and mid-atlantic tel: 321-951-4164 fax: 321-951-4254 international tel: 805-778-9229 fax: 805-778-1980 west coast tel: 949-362-2260 fax: 949-362-2266 northeast tel: 603-888-3975 fax: 603-888-4585 central tel: 719-594-8017 fax: 719-594-8468 www.aeroflex.com info-ams@aeroflex.com aeroflex microelectronic solutions reserves the right to change at any time without notice the specifications, design, function, or form of its products described herein. all parameters must be validated for each customer's application by engineering. no liability is assumed as a result of use of this product. no patent licenses are implied. our passion for performance is defined by three attributes represented by these three icons: solution-minded, performance-driven and customer-focused export control: export warning: this product is controlled for expor t under the international traffic in arms regulations (itar). a license from the u.s. department of state is required prior to the export of this product from the united states. aeroflex?s military and space pr oducts are controlled for export under the international traffic in arms regulations (itar) and may not be sold or proposed or offered for sale to certain countries. (see itar 126.1 for complete information.) ordering information model dla smd # screening package rhd5900-7 - commercial flow, +25c testing only 16-pin soic package rhd5900-s - military temperature, -55c to +125c screened in accordance with the individual test methods of mil-std-883 for space applications rhd5900-201-1s 5962-1024101kxc in accordance with dla smd rhd5900-201-2s 5962-1024101kxa rhd5900-901-1s 5962h1024101kxc in accordance with dla certified rha program plan to rha level "h", 1mrad(si) RHD5900-901-2S 5962h1024101kxa
|
